High Speed Gripper Feeder GS-906A / GS-1512A | Yiming, Dongguan, China

Yiming's High Speed Gripper Feeder GS-906A / GS-1512A pulls strip from the coil and feeds it into a press at up to 1000 strokes per minute (SPM). It is built for high-speed precision metal stamping of small parts.

Two models are offered: the GS-906A for strip up to 90 mm wide and the GS-1512A for strip up to 150 mm wide. A typical line pairs it with an uncoiler, the feeder, a press and an automatic winding machine.

Key Features

• Surface-contact material press area spreads the clamping pressure, so soft material is not scratched
• Feed length is adjusted with a hand wheel on the front, and can be changed while the machine is running
• Feed length is shown on a digital display
• Thickness is set with a bolt on the left side and confirmed on a front dial
• Drive parts sit below the material feeding surface, which makes the guide and grippers easy to clean
• Clutch cam and swing wheel cam are driven by the same device to open and close the grippers
• Adjustable relaxation angle

Technical Specifications

• Models: GS-906A, GS-1512A
• Maximum speed: Up to 1000 SPM
• Material width: 0–90 mm (GS-906A); 0–150 mm (GS-1512A)
• Material thickness: 0.05–1.5 mm
• Material length: 60 mm (GS-906A); 120 mm (GS-1512A)
• Feeding angle: 180°
• Relaxation angle: Adjustable
• Feeding mechanism: Crankshaft
• Installation direction: Left
• Feeding direction: Left to right
• Weight: 188 kg (GS-906A); 218 kg (GS-1512A)

Applications

• High-speed stamping of small hardware parts
• Electronic component stamping
• Precision metal stamping lines fed from coil
• Automatic stamping lines with uncoiler and strip winding

Commercial Details

• Brand: Yiming
• Manufacturer: Dongguan Yiming Jia Equipment Co., Ltd
• Place of origin: Dongguan, Guangdong, China

Frequently Asked Questions

• How fast can the gripper feeder run? It feeds at up to 1000 SPM.
• What strip sizes can it handle? The GS-906A takes strip 0–90 mm wide and the GS-1512A takes 0–150 mm wide, both in thicknesses of 0.05–1.5 mm.
• Can the feed length be changed during production? Yes, the feed length is set with a front hand wheel and can be changed while the machine is running, with a digital display showing the value.
• What should I send for a quotation? Send the strip material, width and thickness, the required feed length, the target press speed in SPM, the press model, and whether you need an uncoiler and winding machine in the line.