Used Bonak Loop Cut To Length Line 1500mm x 3mm | Galaxie Corporation, Wayne, Michigan, USA

This used Bonak loop cut-to-length line is available from Galaxie Corporation. It uncoils, levels and shears coil into flat sheets, and was built in 1982.

It handles strip 300–1,550 mm wide and 0.4–3.0 mm thick from coils up to 25 t, and cuts sheets 500–12,000 mm long at up to 80 m/min. The line is supplied as a complete line, from pit-type coil car through to drop-type stacker.

Key Features

• Pit-type coil car and double expandable mandrel
• Powered hold-down roll and entry guide rolls
• 17-roll Bonak 4-HI leveler with hydraulic actuation
• Five flights of top and bottom motorised back-ups
• Pit cross-over table, conveyor table and feeder roll
• Mechanical shear with drop-type stacker and motorised run-out table
• Supplied with electrics, hydraulics, controls and drawings

Technical Specifications

• Manufacturer: Bonak
• Year: 1982
• Strip width: 300–1,550 mm
• Thickness range: 0.4–3.0 mm
• Maximum coil weight: 25 t
• Coil outside diameter: 600–2,000 mm
• Coil inside diameter: 508–760 mm
• Sheet length: 500–12,000 mm
• Maximum speed: 80 m/min
• Line direction: Right to left
• Leveler: 17-roll Bonak 4-HI
• Shear: Mechanical
• Stacker: Drop type

Applications

• Producing flat steel sheets from coil
• Blanks for fabrication and pressing
• Sheet supply for service centres and metal processors

Commercial Details

• Make: Bonak
• Year: 1982
• Condition: Used
• Location: Wayne, Michigan, USA
• Seller: Galaxie Corporation

Frequently Asked Questions

• What material sizes does the line handle? It processes strip 300–1,550 mm wide and 0.4–3.0 mm thick, from coils up to 25 t.
• What sheet lengths and speed can it run? It cuts sheets 500–12,000 mm long at up to 80 m/min.
• What equipment is included? It includes a pit-type coil car, double expandable mandrel, 17-roll 4-HI leveler, feeder, mechanical shear, drop-type stacker and run-out table.
• What should I ask when enquiring? Ask for photos or video of the line under power, inspection arrangements, confirmation of included equipment, the condition of the control and electrics, and loading and shipping details.