Used Loop Dual Injector Head Slitting Line, 1600 mm | Galaxie Corporation, Wayne, Michigan, USA

This used loop dual injector head slitting line is available from Galaxie Corporation. It cuts wide steel coil into narrower strips and rewinds them, and it is rated for coil up to 63 in (1,600 mm) wide, 0.125 in (3.2 mm) thick and 40,000 lb in weight.

It is a complete line, from entry coil car and uncoiler through the slitting head and loop pit to the recoiler and exit coil car, with hydraulics, controls and electrics. The page lists the line as installed and in operation, and it is dated 2016.

Key Features

• Loop pit with a stated loop depth of 6,000–10,000 mm
• Top and bottom film laminating equipment
• Paper winder and paper interleaving machine
• Entry and exit shears
• Scrap winder / chopper
• Leveling/flattening unit (or sheet feeder) included
• Single-mandrel uncoiler with hydraulic expansion and sliding base

Technical Specifications

• Type: Loop slitting line with dual injector heads
• Year: 2016
• Maximum coil width: 63 in (1,600 mm)
• Maximum thickness: 0.125 in (3.2 mm)
• Maximum coil weight: 40,000 lb
• Loop depth: 6,000–10,000 mm
• Uncoiler: Single mandrel, hydraulic expansion, sliding base, powered hold-down roll, outboard bearing support
• Entry equipment: Coil seat, entry coil car, peeler table, entry guides and pinch rolls, entry shear
• Exit equipment: Tension stand, exit shear and deflector roll, recoiler with pusher plate, exit coil support, exit coil car

Applications

• Slitting steel coil into narrower strips
• Preparing strip for stamping and fabrication
• Supplying coil to tube, roll forming and pressing operations
• Coil processing in service centres

Commercial Details

• Year: 2016
• Condition: Used
• Location: Wayne, Michigan, USA
• Seller: Galaxie Corporation

Frequently Asked Questions

• What coil sizes can this slitting line handle? It is rated for coil up to 63 in (1,600 mm) wide, 0.125 in (3.2 mm) thick and 40,000 lb in weight.
• Is it a complete line? Yes, it runs from the entry coil car and uncoiler through the slitting head and loop pit to the recoiler and exit coil car, with hydraulics, controls and electrics.
• How deep is the loop? The loop depth is 6,000–10,000 mm.
• What should I ask when enquiring? Ask for photos or video of the line running, the slitting head tooling and arbors included, the control system and electrical details, and the loading and shipping arrangements.